13 54 030 Removing and installing/sealing throttle valve assembly (N54, N54T): Notes
WARNING: This page is about a different car, the 2010 BMW X6, 2009 BMW X6, and 2008 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Switch off ignition
- Remove charge-air duct. See 11 61 368 REMOVING AND INSTALLING/REPLACING REAR LEFT CHARGE-AIR DUCT (N54, N54T) and 11 61 368 REPLACING CHARGE-AIR DUCT (N54, N54T) .
Unlock and disconnect line (1).
Unlock connector (2) and remove.
Release screws.
Tightening torque 13 54 1AZ .
Remove throttle assembly (3).