86 21... Adjusting rear lid to fit: Installation

Tightening Torque, height adjustment,

refer to 86 21 7AZ, see 86 21 HOOD .

Tightening Torque, depth adjustment,

refer to 86 21 9AZ, see 86 21 HOOD .

Adjust gap (A) evenly all around without displacement and correct if necessary.

Fig 1: Identifying Gap

Courtesy of BMW OF NORTH AMERICA, INC.

Check lid in transition (B) to hood for displacement and correct if necessary (flush).

Fig 2: Checking Lid In Transition To Hood

Courtesy of BMW OF NORTH AMERICA, INC.

To align lid in transverse direction, you can install or remove plastic washers (3) between hinge bracket (1) and mounting bracket (2).

There must always be a plastic washer (3) fitted on left and right sides of mounting bracket (2). Plastic washers are available in thicknesses of 1 mm and 3 mm.

Fig 1: Identifying Plastic Washers, Hinge Bracket And Mounting Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Check lid in transition (C) to hood (flush) and correct if necessary. Correction is made by inserting or omitting plastic washers (refer to Fig 1).

Fig 2: Checking Lid In Transition To Hood

Courtesy of BMW OF NORTH AMERICA, INC.