61 31 334 Removing and installing or replacing grip trim for gear selector switch

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

64 1 030

NOTE:

See HEATING AND AIR CONDITIONING - SPECIAL TOOLS .

Turn circlip (1) in direction of arrow and remove.

Installation:

Make sure circlip (1) is correctly seated.

Fig 1: Turning Circlip

Courtesy of BMW OF NORTH AMERICA, INC.

Feed special tool 64 1 030 from below into trim (1) and carefully pull off trim (1) in direction of arrow.

Remove symbol plate (2).

Installation:

To facilitate fitting, secure pushbutton (3) with adhesive tape on trim (1).

Fig 2: Secure Pushbutton (3) With Adhesive Tape On Trim (1)

Courtesy of BMW OF NORTH AMERICA, INC.