84 21 541 Removing and installing (replacing) hands-free charging electronics (High)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) .

NOTE: Comply with notes and instructions on handling optical waveguides .

Necessary preliminary tasks:

Remove complete rear console . See 51 16 270 REMOVING AND INSTALLING COMPLETE REAR SECTION OF REAR CONSOLE .

Release nuts (1) and remove rear console holder (2).

Release screw (3) and raise hands-free charging electronics holder (4) in direction of arrow.

Installation:

Make sure centering pin (5) is correctly seated in associated hold of hands-free charging electronics holder (4).

Fig 1: Release Screw (3) And Raise Hands-Free Charging Electronics Holder (4) In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release all nuts.

Remove hands-free charging electronics (2) from hands-free charging electronics holder (3).

Installation:

Make sure wiring harness (4) is laid correctly.

Fig 2: Remove Hands-Free Charging Electronics (2) From Hands-Free Charging Electronics Holder (3)

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/CODING .

If necessary, log mobile phone on to vehicle.