61 35 095 Removing and installing/replacing control unit/module for seat heating (left or right rear seat)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)
.
Necessary preliminary tasks:
- Disconnect battery negative lead
- Unclip and raise rear seat . See REAR SEAT, THROUGH-LOAD .
Feed control unit/module for seat heating (1) out of rear seat (2).
Disconnect plug connections (3) and remove control unit/module for seat heating (1).
Installation:
Lay wiring harness so that it cannot be damaged when rear seat (2) is installed.
Make sure control unit/module for seat heating (1) is correctly seated in rear seat (2).