61 12 062 Replacing wiring harness for front bumper
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on handling wiring harnesses
and cables.
Necessary preliminary tasks:
- Remove front bumper trim . See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .
NOTE:
Work is shown on the E70 by way of example. There may be differences in detail in the case of other vehicle models.
Disconnect plug connections for ultrasonic transducer (1).
Unclip or feed out wiring harness for front bumper (2) from bumper trim and remove.