52 26 301 Removing and installing /replacing actuating mechanism for left rear seat backrest (through-loading system)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Grasp trim (1) for release lever from inside and pry out upward.

Fig 1: Releasing Lever From Inside

G04789184

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining straps (1) must not be damaged.

Fig 2: Retaining Straps

G04789185

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Place cloth (1) over locking rod to prevent the rear seat backrest from locking down.

Pry out actuating mechanism (2) by pulling forwards and upwards.

Fig 3: Prying Out Actuating Mechanism

G04789186

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Locking tabs (1) on left/right sides (for trim on actuating mechanism) must not be damaged.

Locking tabs (2) at front and (3) back (for actuating mechanism) must not be damaged.

Actuating rod (4) must be correctly mounted and should not be bent.

Fig 4: Locking Tabs And Actuating Rod

G04789187

Courtesy of BMW OF NORTH AMERICA, INC.