51 13 420 Removing and installing/replacing center rear-end trim section

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317 00 9 310 ASSEMBLY WEDGES (SET IN PLASTIC CASE)

Necessary preliminary tasks:

Remove number/license plate.

Release screws (1).

Tightening torque: 51 13 4AZ, see 51 13 TRIM PARTS, COVERS, HANDLE TRIM

Fig 1: Screws

G04788440

Courtesy of BMW OF NORTH AMERICA, INC.

Attach adhesive tape (1) underneath center rear-end trim section (2) (risk of damage).

Unclip clips (3) with special tool 00 9 317.

Pull off center rear-end trim section (2) in direction of arrow a little.

Fig 2: Special Tool (00 9 317)

G04788441

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) at center rear-end trim section (2).

Remove center rear-end trim section (2).

Fig 3: Centre Rear-End Trim Section And Plug Connection

G04788442

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit all clips (1) with sealing ring.

If necessary, replace faulty clips (1).

Replacement:

Remove handle strip (3).

Fig 4: Handle Strip And Clips

G04788443

Courtesy of BMW OF NORTH AMERICA, INC.