37 14 512 Replacing rear ride-height sensor (early version)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Disconnect plug connection (1).

Release nut (3) and disconnect jointed rod.

Tightening torque: 37 14 7AZ , see 37 14 ELECTRIC COMPONENTS .

Release screws (4) and remove ride-height sensor.

Installation:

Sensor lever (2) must point from ride-height sensor to right rear wheel.

Tightening torque: 37 14 6AZ , see 37 14 ELECTRIC COMPONENTS .

Fig 1: Plug Connection, Nut, Screws And Sensor Lever

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check headlight adjustment, correct if necessary, see 63 10 004 ADJUSTING HEADLIGHTS .