41 61 000 Removing And Installing Engine Hood
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Support engine hood in fully opened position with suitable apparatus. Risk of injury.
NOTE:
Carry over schematic representation to the relevant vehicle type.
Loosen screws (1).
Unfasten screws (2).
Remove hood lid.
Installation:
Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.
If this is not possible, adjust engine hood, see 41 61 014 Adjusting engine bonnet/hood .
Tightening torque: 41 61 1AZ, see 41 61 ENGINE BONNET/HOOD .