41 00... Installing A Cavity Bulkhead (Not Expanded)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry over schematic representation to the relevant vehicle type.
The following repair represents replacement of a cavity bulkhead.
Before these work steps, prepare the new part so that it is ready to install (adapting, cutting to size, applying welding primer etc.).
Sand contact surface of cavity bulkhead (1) with coarse-grained abrasive paper (grain 50 - 100).
Clean contact surface (1) with spirit.
Apply an approx. 15 mm high bead of original BMW window adhesive to contact surface (1).
Attach cavity bulkhead in specified position (see old part).
Fit, secure and weld up new part.
WARNING:
Ensure adequate ventilation over entire processing period.