34 52 525 Replacing one front pulse generator

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Read and comply with General Information, see 34 00 ... General Information .

Open plug housing (1), pull plug connection (2) out of fixture and disconnect.

Pull cable with rubber grommet out of fixture on spring strut and on body.

Installation:

Ensure proper locking of plug connector and proper seating of rubber grommets.

Fig 1: Pulling Plug Connection And Plug Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Release socket head cap screw (1).

Withdraw pulse generator (2) from bore.

Installation:

Tightening torque: 34 51 6AZ, see 34 51 SLIP CONTROL SYSTEM (ABS, ASC+T, DSC) .

Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease.

Fig 2: Socket Head Cap Screw And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.