31 10 010 Removing and installing/replacing reinforcement plate

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe safety instructions for raising the vehicle, see 00 ... ... LIFTING VEHICLE WITH A LIFTING PLATFORM .
Driving without reinforcement plate is not permitted!

If necessary, release screws (1).

Remove expander rivet (2).

If necessary, remove rear assembly underside protection or shield on reinforcement plate, see 51 47 491 Removing and installing/replacing rear underbody protection .

Release screws (3).

Remove reinforcement plate.

Installation:

Replace screws.

Tightening torque: 31 10 9AZ, see 31 10 FRONT AXLE SUSPENSION .

Fig 1: Expander Rivet And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, modify absorber, cover, cover with absorber and air routing duct.