27 10 710 Replacing resistor for servomotor (ATC 400 X-Drive)

WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Delete previous resistance values when replacing the resistor.
Using BMW diagnosis system, work through test program in accordance with instructions.

Release screws and remove transmission cross-member.

Tightening torque: 27 00 10AZ, see 27 00 TRANSFER BOX IN GENERAL .

Fig 1: Transmission Cross-Member Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Detach plug (1) from resistor.

Release screw (3) and remove resistor.

Tightening torque: 27 00 14AZ, see 27 00 TRANSFER BOX IN GENERAL .

Fig 2: Plugs And Servomotor

Courtesy of BMW OF NORTH AMERICA, INC.