27 10 050 Replacing output flange for front axle output (ATC 400/500 X-Drive)
WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not move vehicle with engine power once propeller shaft has been removed.
Replace output flange only in conjunction with a new radial shaft seal.
After completion of work, check transmission oil level, see 00 11 572 CHANGING OIL IN TRANSFER BOX (ATC 400/500)
Use only approved transmission oil.
Failure to comply with this requirement will result in serious damage to the transfer box!
Replace output flange only in conjunction with a new radial shaft seal.
After completion of work, check transmission oil level, see 00 11 572 CHANGING OIL IN TRANSFER BOX (ATC 400/500)
Use only approved transmission oil.
Failure to comply with this requirement will result in serious damage to the transfer box!
Operation is identical to Replacing radial shaft seal for front axle output, see 27 21 030 Replacing radial shaft seal for front axle output (ATC 400/500 X-Drive) .