86 21 ... Removing Rotary Striker Lock

The following text describes how to remove the rotary striker lock on the rear lid as an example. Proceed in the same way for the side lids. Remove the lock while the lid is open.

Release screws (1) and remove cover (2). On rear lid, remove red cap (3).

Installation, rear lid only:

Place red cap back on pull rod. Red cap serves to indicate rear lid emergency unlocking facility.

Fig 1: Identifying Screws, Cover & Red Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Remove spring nut (1) from pull rod (2).

Installation: 

Use new spring nut.

Fig 2: Identifying Spring Nut & Rod

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook pull rod (1) from rocker (2).

Fig 3: Identifying Rod & Rocker

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove rotary striker lock (2) from opening (3).

Installation: 

Tightening Torque, refer to 86 21 HOOD .

Use new Stover nuts.

Fig 4: Identifying Sealing Compound & Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Detach spring nut (1) from pull rod (2). Remove pull rod (2) from rotary striker lock (3).

Installation: 

Use new spring nut.

Fig 5: Identifying Spring Nut, Rod & Rotary Striker Lock

Courtesy of BMW OF NORTH AMERICA, INC.