61 12 210 Replacing wiring harness in left or right rear door
WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Close rear side window completely
- Remove cover on door handle, see 51 41 017 REMOVING AND INSTALLING/REPLACING COVER ON DOOR HANDLE, FRONT LEFT OR RIGHT
- Remove rear door trim panel, see 51 42 000 REMOVING AND INSTALLING LEFT OR RIGHT REAR DOOR TRIM PANEL
- Remove rear acoustic insulation, see 51 48 070 REMOVING AND INSTALLING/REPLACING SOUND INSULATION ON LEFT OR RIGHT REAR DOOR
Disconnect plug connection (1) on power window unit.
Unclip door wiring harness at points (2).
Installation:
Make sure door wiring harness is correctly laid.
Release screw (1), fold door wiring harness plug on B-pillar (2) downwards slightly and remove.
Unlock plug connection behind and disconnect.
Pull rubber grommet (3) out of rear door.
Feed out door wiring harness towards front to B-pillar and remove.