00 00 ... Diagnostic brief test
WARNING: This page is about a different car, the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, and 2007 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
- Connect BMW diagnosis system (DIS) to diagnosis socket or OBD socket
- Switch ignition on
- Carry out vehicle identification
- Start brief test
NOTE:
For diagnostics, the brief test is essential for evaluating possible stored diagnostic trouble codes. In the brief test, the control units are physically identified in succession and their fault memories read out.
Check identified faults and if necessary rectify these faults after consulting with customer.
Check identified faults and if necessary rectify these faults after consulting with customer.
Connect diagnostic system to OBD socket.
Switch on ignition.
Carry out vehicle identification.
Click on Brief test.
The brief test is carried out.
NOTE:
For motor vehicle diagnostics, the brief test is essential for evaluating possible stored diagnostic trouble codes.
In the brief test, the control units are physically identified in succession and their fault memories read out.
If the fault memory has been read out, the faults appear in the "Fault pattern selection" mask in the "Fault memory contents" field.
Check identified faults and if necessary rectify these faults after consulting with customer.
In the brief test, the control units are physically identified in succession and their fault memories read out.
If the fault memory has been read out, the faults appear in the "Fault pattern selection" mask in the "Fault memory contents" field.
Check identified faults and if necessary rectify these faults after consulting with customer.