11 34 715 Replace all valve springs (M57T2- SCR)

Necessary preliminary work:

Remove CYLINDER HEAD .
Disassemble CYLINDER HEAD
Place cylinder head on special tool 11 9 001.

Position special tool 11 9 008 with straight surface on combustion chamber side of cylinder head (see illustration).

NOTE: Procedure for all 4, 6 and 8-cylinder diesel engines.

Fig 1: Positioning Special Tool (11 9 008) On Combustion Chamber Side Of Cylinder Head

G06852686

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 11 9 006 and lock with special tool 11 9 005 in direction of arrow.

Fig 2: Locking Special Tool (11 9 006) Using Special Tool (11 9 005)

G04739695

Courtesy of BMW OF NORTH AMERICA, INC.

Lock special tool 11 9 005 in direction of arrow.

Rotate cylinder head, using special tool 11 9 000, 180° into installation position.

Fig 3: Rotating Cylinder Head Using Special Tool (11 9 005)

G04739696

Courtesy of BMW OF NORTH AMERICA, INC.

Align special tool 11 9 009 in direction of valve axis. Select corresponding groove in special tool 11 9 015.

Press down valve spring on upper spring cup with special tool 11 9 009.

Hook in with special tool 11 9 011.

Fig 4: Pressing Valve Spring On Upper Spring Cup Using Special Tool (11 9 009)

G06852688

Courtesy of BMW OF NORTH AMERICA, INC.

Remove valve keys.

Remove valve spring and spring cup.

Fig 5: Removing Valve Keys

G04207672

Courtesy of BMW OF NORTH AMERICA, INC.

Installation sequence:

Valve
Valve stem seal
Valve spring
Top spring cup
Valve keys

Fig 6: Valve Assembly Parts Installing Sequence

G06853064

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, replace VALVE STEM SEALS .

Assemble engine.