11 28 050 Removing and installing/replacing drive belt (elastobelt) for power steering pump (M57TU2)
Necessary preliminary tasks:
- Remove front splash guard.
- Mark the direction of rotation of the drive belt if it is to be reused.
Rotate engine with special tool 11 6 480 in direction of engine rotation.
At the same time, pull off drive belt (2) towards front in direction of arrow using a clean cloth (1).
Remove drive belt (1) towards front.
Fit drive belt (1) on A/C compressor.
Draw drive belt (1) with special tool 11 0 330 onto belt pulley in direction of arrow.
Installation:
Check installation position of drive belt.
Assemble engine.