51 49 090 Removing And Installing/Replacing Panel For Rear Lid Lower Section

Raise trim (1) and disengaged springs (2).

Release screws (3).

IMPORTANT: Risk of damage!
When springs (2) are disengaged, rear lid must not be closed.

Fig 1: Identifying Trim And Springs

Courtesy of BMW OF NORTH AMERICA, INC.

Starting at side, pull panel (1) upwards and release from catches (2).

Fig 2: Identifying Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) and guides (2) must not be damaged.

Make sure catches (1) and guides (2) are correctly seated.

Fig 3: Identifying Catches And Guides

Courtesy of BMW OF NORTH AMERICA, INC.