51 33 000 Removing And Installing (Replacing) Power Window Unit In Left Or Right Front Door

NOTE: When removing door lock, snap door window glass out only, do not remove, secure in door window frame.

Necessary preliminary tasks:

Release cable in area (A) from holder.

Release nuts (1) and feed out rear section of power window unit (2).

Fig 1: Identifying Nuts And Power Window Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and feed out front section of power window unit (2).

Fig 2: Identifying Nuts And Power Window Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1 to 3) and remove flat motor (4).

Installation:

To avoid distortion, observe screw-in sequence.

Fig 3: Flat Motor Screws Tightening/Loosening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.