63 14 120 Removing and Installing/Replacing Rear Reflector

Special tools required: 

• 00 9 317. See ASSEMBLY WEDGES (SET IN PLASTIC CASE)
• 00 9 323. See ASSEMBLY WEDGES (SET IN PLASTIC CASE)

Unclip rear reflector (1) with special tool 00 9 323. See ASSEMBLY WEDGES (SET IN PLASTIC CASE) on right side and press inwards with special tool 00 9 317. See ASSEMBLY WEDGES (SET IN PLASTIC CASE) .

Remove rear reflector (1) towards rear from rear bumper trim.

Fig 1: Removing Rear Reflector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Catches (1) on rear reflector must not be damaged.

If necessary, replace faulty retainer (2).

Fig 2: Identifying Faulty Retainer And Catches

Courtesy of BMW OF NORTH AMERICA, INC.