51 16 372 Removing And Installing/Replacing Lower GLOVEBOX Lid

Necessary preliminary tasks:

Close glovebox lid.

Release tab washer (1) and remove pin (2).

Installation:

Replace tab washer (1) and pin (2).

Fig 1: Identifying Tab Washer And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Drive out shaft (1) in direction of arrow until knurled area (2) is exposed.

Pull out shaft (1) completely and remove glovebox lid.

Installation:

Check that shaft (1) is securely seated.

If necessary, fit flap fastening set.

Fig 2: Identifying Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty bushings (1).

Markings (2) on bushing (1) and glovebox lid (3) must line up.

Fig 3: Identifying Bushings And Glovebox Lid

Courtesy of BMW OF NORTH AMERICA, INC.