51 14 011 Replacing Rear BMW Badge

Special tools required:

00 9 323

IMPORTANT: The Instructions on component cementing with double - sided adhesive tape serve as the basis for this repair instruction and must be observed without fail. See 51 14 ... INSTRUCTIONS FOR ATTACHING NUMBER/LETTER DESIGNATION COMBINATION
The BMW badge must be replaced after it is removed.

Removing badge:

Heat BMW badge (1) with hot air blower and carefully lever out with special tool 00 9 323.

Fig 1: Identifying Special Tool (00 9 323)

Courtesy of BMW OF NORTH AMERICA, INC.

Fitting badge:

Installation:

Grommets (1) must not be damaged.

Fig 2: Identifying Grommets And Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.

Pull liner* off adhesive tape (2), position badge over guide pins (3) and press down firmly.

* Liner is the protective film on a new badge.