51 11 157 Replacing Front Bumper Trim
Necessary preliminary tasks:
- Remove front bumper trim . See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .
- Remove license plate holder . See 51 11 158 REPLACING BASEPLATE FOR LICENSE PLATE .
- Remove bottom middle grille . See 51 11 180 REMOVING AND INSTALLING/REPLACING GRILLE IN BUMPER TRIM (BOTTOM MIDDLE) .
- Remove side grille . See 51 11 185 REMOVING AND INSTALLING/REPLACING GRILLE (SIDE) IN BUMPER TRIM .
- Remove top grille . See 51 11 182 REMOVING AND INSTALLING/REPLACING GRILLE IN BUMPER TRIM AT TOP .
- Remove cover caps for tow lug
Version with Park Distance Control (PDC):
- Remove ultrasonic transducer . See 20 PARK DISTANCE CONTROL .
Installing trim (2) for grille:
Remove ribs (1) from trim (2) completely.
Attach trim (1) to bumper trim.
NOTE:
Make sure catches (2) and lugs (3) are correctly seated.
Secure trim (1) with retainers (2).
NOTE:
Retainers (2) must press trim (1) fully onto bumper trim.
Also secure retainers (2) with adhesive.
NOTE:
Lugs and retainers (2) must be free of grease, clean if necessary.
Observe an air drying time at least 1 minute.