66 53 ... Instructions For Adapting Adjustment Unit For Reversing Camera (CORGHI KDS Quick - Action Clamp)

NOTE: The operation is described for the left-hand side; proceed in the same way for the right-hand side.

Remove support plate (1) from spindle (2).

Replace spindle (2) by spindle (3).

Press support plate (1) on to spindle (3).

Fig 1: Identifying Support Plate And Spindle

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining clip (1).

Remove ball pin (2) from rod (3).

Fig 2: Identifying Retaining Clip And Ball Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Fit new ball pin (1) on rod (2) and secure with retaining clip (3).

Fit ball pin (1) on CORGHI KDS quick-release clamp and secure.

Fig 3: Identifying Ball Pin And Rod

Courtesy of BMW OF NORTH AMERICA, INC.

Remove all spacers (1) on cross bar (2).

NOTE: Follow the same procedure for calibrating the reversing camera.

Fig 4: Identifying Spacers And Cross Bar

Courtesy of BMW OF NORTH AMERICA, INC.