51 12 080 Removing and installing/replacing trim on loading sill for rear bumper (from 09/2006)

NOTE: Trim (1) is if necessary secured to bumper with double-sided adhesive tape (3).

Lever out trim (1) from bumper (2).

Installation:

Make sure trim (1) is correctly seated on bumper (2).

Fig 1: Trim And Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Engage trim (1) in bumper (2).

Fig 2: Trim And Bumper

Courtesy of BMW OF NORTH AMERICA, INC.