51 11 141 Removing and installing/replacing bumper trim lower section (up to 09/2006)

Necessary preliminary tasks:

Release screws (1) on left/right.

Unhook catches (2) on left/right from bumper trim (3).

Fig 1: Catches, Screws And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release catches (1) and remove lower section of bumper trim (2).

Fig 2: Catches And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Lever cover (1) in direction of arrow out of lower section of bumper trim (2).

Fig 3: Cover And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on lower section of bumper trim (2) must not be damaged.

Fig 4: Catches And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty metal nuts (1) on lower section of bumper trim (3).

When replacing with Park Distance Control version:

Remove ultrasonic transducer (2) from lower section of bumper trim (3).

Remove locators (4) and spacer rings (5).

Fig 5: Locators, Spacer Rings And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, cut out openings for ultrasonic sensors (2) on lower section of bumper trim (1) at moldings.

Fig 6: Ultrasonic Sensors And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.