72 11 102 Removing and installing/replacing all rear seat belts

Necessary preliminary tasks:

Removing left and right inertia reel units:

Release screw (1) on left and right inertia reel units (2).

Tightening torque: see 20AZ in 72 11 SEAT BELTS .

Remove left and right inertia reel units (2).

Removing middle inertia reel unit:

Unscrew bolt (3).

Tightening torque: see 20AZ in 72 11 SEAT BELTS .

Remove inertia reel unit (4).

Installation:

Guide lug of inertia reel unit (4) must be correctly seated in opening in body.

Fig 1: Identifying Reels, Bolt And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pay attention to coding on inertia reel unit (1) and on body (2).

Fig 2: Identifying Inertia Reel Unit And Body

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2) on left and right.

Tightening torque: see 22AZ in 72 11 SEAT BELTS .

Remove left and right seat belts (1).

Installation:

Secure fittings of left and right seat belts (1) through guides (2) and stop (3).

Fig 3: Identifying Seat Belts, Guides And Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Removing lower strap receptacles:

lease screws (1).

Tightening torque: see 23AZ in 72 11 SEAT BELTS .

Remove lower strap receptacles (2).

Remove middle upper strap (3).

Fig 4: Identifying Lower Strap Receptacles, Screws And Middle Upper Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Ensure correct installation sequence and installation position:

Fittings of center lower strap/center upper strap must rest on stop (1).
Secure lower strap on left and right through guides (2).

Fig 5: Identifying Guides And Stop
Courtesy of BMW OF NORTH AMERICA, INC.