63 12 861 Replacing control unit for right xenon headlight

WARNING: This page is about a different variant/trim than selected.

WARNING: Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the power supply (lighting system and ignition off).
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by specialist personnel.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks

Remove front right wheel arch trim

N54/S65:

Remove RIGHT HEADLIGHT

NOTE: Headlight removed for purposes of clarity.

Release screws (1). Tightening torque 63 12 4AZ .

Lift control unit (2) off headlight.

Fig 1: Identifying Control Unit And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Remove control unit (2).

Installation:

Make sure sealing sleeve (3) is correctly seated.

Fig 2: Identifying Plug Connection, Control Unit And Sealing Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.