37 14 512 Replacing rear ride-height sensor (M3)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release nut (1) and disengage jointed rod (2) on ride-height sensor.

Installation:

Replace self-locking nut.

Sensor lever (3) must point starting from ride-height sensor to left rear wheel.

Tightening torque 37 14 3AZ .

Fig 1: Identifying Lever, Ride-Height Sensor And Jointed Rod

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (4) and remove ride-height sensor with holder from rear axle carrier.

Installation:

Align holder to corresponding bore in rear axle carrier.

Tightening torque 37 14 2AZ .

Disconnect plug connection (1).

Release screws (3) and remove ride-height sensor from bracket (2).

Installation:

Tightening torque 37 14 1AZ .

Fig 2: Identifying Plug Connection And Ride-Height Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation