37 14 511 Replacing front ride-height sensor

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release nut (1) and disconnect jointed rod (2).

Installation:

Tightening torque 37 14 3AZ .

Fig 1: Identifying Plug Connection, Jointed Rod With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (4).

Remove ride-height sensor and disconnect plug connection (3).

Installation:

Sensor lever (5) must point from ride-height sensor to left front wheel.

Tightening torque 37 14 1AZ .

After installation

Check headlight adjustment . See 6310004 ADJUSTING HEADLIGHTS or 6310004 ADJUSTING HEADLIGHTS , correct if necessary