65 81 060 Removing and installing/replacing outside temperature sensor (M3)

WARNING: This page is about a different variant/trim than selected.

Release screws (1 and 2).

Remove tip of engine compartment shield (3) on left/right.

Installation:

Make sure tip of engine compartment shield (3) is installed in correct position.

Fig 1: Identifying Engine Compartment Shield With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unclip outside temperature sensor (2) in direction of arrow and remove.

Installation:

Outside temperature sensor (2) must audibly snap into place.

Ensure correct seating in air duct (3).

Fig 2: Removing Outside Temperature Sensor

Courtesy of BMW OF NORTH AMERICA, INC.