65 83 590 Removing and installing/replacing gyro sensor drive for Car Communication Computer

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove CAR COMMUNICATION COMPUTER

If necessary, cut through warranty seal.

Release bolts (1).

Remove floor pan (2) towards bottom and set down.

IMPORTANT: Contact spring strip (3) on floor pan (2) must not be bent: otherwise risk of short-circuiting!
When reinstalling floor pan (2), make sure individual springs of contact spring strip (3) are correctly seated.

Fig 1: Identifying Bolts Of Floor Pan And Spring Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (1).

Detach gyro sensor for Car Communication Computer (2) in direction of arrow from plug-in contact (3).

Fig 2: Removing Gyro Sensor From Plug-In Contact

Courtesy of BMW OF NORTH AMERICA, INC.