65 83 570 Removing and installing/replacing CD drive for Car Communication Computer

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) !

Necessary preliminary tasks

If necessary, cut through warranty seal.

Raise cover (1) with special tool 64 1 020 HOOK all round and remove from Car Communication Computer (2).

Fig 1: Raising Cover Using Special Tool (64 1 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1).

Feed CD drive for Car Communication Computer (2) in direction of arrow out of Car Communication Computer (3) and set down.

Installation:

Ensure correct routing of cables.

Fig 2: Removing CD Drive Out Of Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts (1).

Remove CD drive trim (2) in direction of arrow from CD drive for Car Communication Computer (3).

Installation:

Ensure correct routing of cables.

Fig 3: Removing CD Drive Trim From CD Drive

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through warranty seal (1) at marked point.

Release screw (2).

Lift side cover out of mounting (3) and carefully place to one side.

Fig 4: Identifying Warranty Seal With Mounting And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove CD drive.

Installation:

Ensure correct routing of cables.

Fig 5: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.