65 75 071 Removing and installing (replacing) module for interior movement detector

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Necessary preliminary tasks:

Open retaining shook (1), and detach and remove module for passenger compartment sensor (2) from trim (3) in direction of arrow.

Installation:

Retaining hooks (1) must not be damaged.

Fig 1: Removing Module For Passenger Compartment Sensor From Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming and encoding .