Preparation of new part

Mark new part in accordance with severance cut on car and cut.

Open weld joints in areas (1) on both sides.

Open weld joints in area (2).

Detach remainder of reinforcement from engine carrier.

Fig 1: Identifying Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in areas (1).

Take off holder.

Fig 1: Identifying Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Adjust new part to fit with straightening attachment or universal mount.

Fig 2: Identifying Straightening Attachment Or Universal Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Weld new part in area (1) with additional MAG weld seams.

Fig 3: Identifying MAG Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.