41 11 023 Stripping Operations - Replacing Front Section Of Engine Support With Left Wheel Arch

WARNING: This page is about a different variant/trim than selected.

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.

Disconnect battery negative lead (FR number: 6120900)
Remove bumper trim (FR flat rate number: 5111156)
Remove headlight (FR number: 6312010)
Remove bumper carrier (FR number: 5111050)
Remove front panel (FR number: 4133040)
Remove radiator (FR number: 1711000)
Remove A/C system condenser (FR number: 6453550)
If necessary, remove intercooler (FR number: 1751000)
If necessary, remove coolant expansion tank (FR number: 1710000)
If necessary, remove air filter housing (FR number: 13)
Remove hydraulic steering cooling coil (FR number: 1711370)
Remove cowl panel cover (FR number: 5113116)
Remove left wheel arch cover (front section) (FR number: 5171038)
Remove left wheel arch cover (rear section) (FR number: 5171039)
Remove left side panel (FR number: 4135010)
Remove engine (FR number: 1100050)
Remove and install complete front axle (FR number: 3110000)
Remove tandem brake master cylinder (job number: 6034000)
Remove brake booster (FR number: 3433000)
Release left wiring harness