41 33 040 Replacing Front Wall

WARNING: This page is about a different variant/trim than selected.

Read general service information under BODY, GENERAL .

Necessary preliminary tasks:

IMPORTANT: Car must not be driven without the front wall.
Driving without the front wall may damage the body structure.

Following new body parts are required:

Fig 1: Identifying Front Panel With Left And Right Headlight Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Carry over the following work steps symmetrically to the other side of the car.

NOTE: View, front side panel, in direction of travel

Release screw (1).

Tightening torque 41 33 3AZ .

Fig 2: Identifying Front Side Panel Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 41 33 1AZ .

Remove front panel (2) together with headlight holder (3).

Replacement:

Release screws (4) and remove headlight holder.

Tightening torque 41 33 2AZ .

Fig 3: Identifying Front Panel, Holder With Screws

Courtesy of BMW OF NORTH AMERICA, INC.