41 61 000 Removing And Installing Engine Compartment Lid

WARNING: This page is about a different variant/trim than selected.

Read general service information under BODY, GENERAL .

Necessary preliminary tasks:

IMPORTANT: For the following work step, secure the engine hood against falling closed.

Disconnect gas-pressure damper from engine hood (1).

Loosen screws (2).

Release screws (3).

Tightening torque 41 61 1AZ .

Fig 1: Identifying Gas-Pressure Damper With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: This work step must be carried out with a second person assisting.

Remove hood lid.

Installation:

Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.

If this is not possible, ADJUST ENGINE HOOD .