25 12 060 Replacing shift lever knob for twin clutch transmission S65

WARNING: This page is about a different variant/trim than selected.

Press installation frame of gaiter (1) a little from front to rear and release gaiter from center console.

Fig 1: Removing Gaiter From Centre Console

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Do not twist shift lever knob during removal as this would cause the turning lock in the knob to shear off.

Tug firmly to remove knob.

Installation:

Fit shift lever knob on shift lever, align and press on until it snaps noticeably into place.

Fig 2: Fitting Shift Lever Knob On Shift Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect connector (1).

Installation:

Note installation position of cables.

Fig 3: Identifying Connector

Courtesy of BMW OF NORTH AMERICA, INC.