26 11 051 Replacing flexible disc for front propeller shaft
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove PROPELLER SHAFT from transmission and center bearing
NOTE:
To protect universal joints, tie back propeller shaft in area of center mount.
Release screws and remove flexible disc (1) from propeller shaft.
IMPORTANT:
Replace shiny ZNS bolts and self-locking nuts.
Tightening torque and angle of rotation: 26 11 1AZ .
Installation:
- Arrows (3) on circumference of flexible disc must point to flange arms (2).
- Grip mounting bolts of flexible disc at propeller shaft flange at nuts and tighten down at bolt heads.
Installation:
Check centering mount.
Replace damaged CENTERING MOUNT .