52 26 311 Removing and installing/replacing lock for left or right rear seat backrest (through-loading system)

Unlock rear seat backrest and fold down.

Unclip Bowden cable from holders (1).

Unfasten screws (2).

Tightening torque 52 26 08AZ .

Fig 1: Identifying Bowden Cable Holders And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull lock (1) out of installation opening slightly and unclip Bowden cable (2).

Remove lock completely from installation opening.

Installation: 

Catches (2) on lock must not be damaged.

Bowden cable must be correctly anchored in catches (2).

Fig 2: Pulling Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Slide guide lug (1) of lock into opening (2).

Fig 3: Sliding Guide Lug Of Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting lock: 

• Slacken screws
• Firmly push engaged backrest back
• Tighten down screws