52 26 303 Removing and installing/replacing actuator for left or right rear seat backrest (through-loading system)

WARNING: This page is about a different variant/trim than selected.

Unclip Bowden cable (1).

Unfasten screws (2).

Unlock catch (3) to center of vehicle and at same time unclip actuator (4) towards bottom.

If necessary, unclip actuator (4) with special tool 00 9 317 .

Fig 1: Removing Actuator

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) and (2) of actuator (3) must not be damaged.

Bowden cable (4) must be correctly engaged in actuator (3).

Fig 2: Identifying Catches Of Actuator

Courtesy of BMW OF NORTH AMERICA, INC.