52 14 050 Removing and installing or replacing lumbar cushion on front seat

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Detach backrest cover (1) from backrest frame.

Fig 1: Removing Backrest Cover From Backrest Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock quick connector and detach air hoses (1 and 2) from valve housing (3).

NOTE: Connections are coded against incorrect assembly.

Fig 2: Identifying Air Hoses And Valve Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Detach lumbar cushion (1) from spring wire (2).

Installation:

Attach lumbar cushion (1) to third and fifth wires from below.

Unclip air hoses (3) and (4) from holder.

Fig 3: Locating Lumbar Cushion On Spring Wire And Air Hoses

Courtesy of BMW OF NORTH AMERICA, INC.

Press back support (1) a little.

Pull out lumbar cushion (2) towards top.

Feed air hoses out of backrest frame and spring wire.

Fig 4: Pulling Lumbar Cushion

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check lumbar cushion at top (1) and bottom (2) for damage.

Air hoses (3) must not be kinked.

Fig 5: Identifying Lumbar Cushion And Bottom Area And Air Hoses

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: