16 12 010 Removing and installing/replacing carbon canister (DMTL)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Disconnect plug connection (1).

Unlock quick-release fasteners (2) and disconnect vent lines.

Release screws (3) and remove carbon canister (4).

Installation:

Tightening torque 16 13 1AZ .

Fig 1: Identifying Plug Connection, Fasteners And Carbon Canister

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Lug (1) must be correctly seated in guide (2).

Fig 2: Identifying Guide And Lug

Courtesy of BMW OF NORTH AMERICA, INC.