11 22 513 Replacing roller bearing for dual-mass flywheel

WARNING: This page is about a different variant/trim than selected.

NOTE: Flywheel removed!

Position special tool 11 2 010 in roller bearing.

Twist out roller bearing with special tool 11 2 343.

Fig 1: Twisting Out Roller Bearing Using Special Tool (11 2 343)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble special tools 11 2 350 and 00 5 500 MANDREL .

Drive in roller bearing with special tools 11 2 350 and 00 5 500 MANDREL in direction of arrow as far as it will go.

Fig 2: Driving Roller Bearing Using Special Tools (11 2 350) And (00 5 500)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

NOTE: Flywheel removed!

Using hydraulic press (1) and special tool 21 2 051, press out dual-mass flywheel downwards on engine side.

IMPORTANT: Risk of damage:
Roller bearing must not be driven out.

Fig 1: Pressing Dual-Mass Flywheel Using Special Tool (21 2 051) And Hydraulic Press

Courtesy of BMW OF NORTH AMERICA, INC.

Push roller bearing (2) onto special tool 21 2 052.

Using hydraulic press (1), press roller bearing into dual-mass flywheel as far as it will go on clutch side.

IMPORTANT: Risk of damage:
Observe press-in instruction:

Roller bearing must not be driven in.
Roller bearing mounting force/travel monitored:
Min. 2000N 1 mm before end of pressing in.

Max. 15000N during entire press-in procedure.

Fig 2: Pressing Roller Bearing Into Dual-Mass Flywheel Using Hydraulic Press

Courtesy of BMW OF NORTH AMERICA, INC.