31 35 021 Replacing both rubber mounts of stabilizer mounting on front axle carrier (M3)

WARNING: This page is about a different variant/trim than selected.

NOTE: Rubber mounts (consisting of upper and lower sections) must be replaced in pairs.

Necessary preliminary tasks

IMPORTANT: When installing the stabilizer, make sure the rubber mount lower section is correctly engaged on both sides.

NOTE: Insert a screwdriver on both sides between retaining bracket (1) and rubber mount lower section (3).

Snap out retaining bracket (1).

Remove rubber mount lower section (3) and rubber mount upper section (2).

Installation:

Make sure rubber mount halves contact stabilizer stop correctly.

Fig 1: Identifying Retaining Bracket, Rubber Mount Of Lower And Upper Section

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep retaining bracket (1), rubber mount upper section (2), rubber mount lower section (3) and stabilizer clean and free from oil and grease.

Insert rubber mount upper section (2) in retaining bracket (1). Guide (4) must be correctly seated in opening (5) in the process.

Catches on rubber mount lower section (3) must not be damaged and must be located in the designated recesses in the retaining bracket (1).

Fig 2: Identifying Retaining Bracket, Rubber Mount Of Lower And Upper Section And Guide

Courtesy of BMW OF NORTH AMERICA, INC.