18 40010 Removing and installing/replacing left exhaust manifold (S65)

WARNING: This page is about a different variant/trim than selected.

WARNING: Scalding hazard!
Only perform these tasks on an engine that has cooled down.

Necessary preliminary tasks

Remove ALTERNATOR (S65) .
Remove COMPLETE EXHAUST SYSTEM
Secure ENGINE IN INSTALLATION POSITION (S65)
Lower FRONT AXLE CARRIER

NOTE: For purposes of clarity, the following work steps are shown on the engine after it has been removed.

Release screws.

Remove 5 heat shield bolts.

Release 2 nuts of individual flange pairs. Remove exhaust manifold. Installation: Replace nuts. Tightens nuts on each flange. Tightening torque, see 18 40 1AZ in EXHAUST MANIFOLD, EXHAUST SYSTEM . Replace seals.